The New Manual.
Nothing To Loosen.
NM-01 is the latest revision of our hand-wheel mobile shelving. Uprights are roll-formed with ribs in one continuous pass, shelves clip onto the hang plates with no screws, and the chassis is a welded 3.0 mm frame. Fewer fasteners means less to work loose, and a stiffer bay under full load.
- Screwless clip assembly — nothing to work loose
- 80 kg per shelf UDL across six double-sided levels
- 10-year structural warranty
Engineered Down
To The Millimetre.
Uniformly distributed load tested across a 900 mm bay; deflection stays under L/200.
1.5 mm cold-rolled upright formed in one pass with four round ribs, so there is no welded joint in the load path.
Chassis and cross members are 3.0 mm hot-rolled steel, welded into a single rigid frame.
Shelves are roll-formed through six folds and finished with anti-inertia stops at the front edge.
Hardened cast-iron rollers run on a solid square rail: no flat spots and no step at the rail joins.
Warranty covers frame, hand-wheel assembly and bearings under normal operating conditions.
Zero Power.
Zero Downtime.
Removing motors, sensors and control boards removes the three most common failure modes in a store: drive-board faults, sensor drift and power-loss lockouts.
Hang plates, divider rods and the dust cover clip into place; the only tools on site are for the rail.
Continuous ribs through the upright section raise stiffness without adding weight or cost.
The crank folds flat against the column so it never blocks the aisle; ≤ 11.8 N moves a loaded run.
Standard modules bolt onto the existing rail; new bays match older runs in height and colour.
Factory Tests
We Document.
Every production batch is subjected to dimensional, load and surface-finish checks before despatch.
Weld Inspection
Chassis welds are visually checked, and critical joints are inspected for porosity under magnification.
Coating Thickness
Powder coat is measured at 60–80 μm; cross-hatch adhesion testing confirms finish integrity.
Load Deflection
Each shelf design is loaded to 120 % of rated capacity for 24 hours with no permanent set.
Hand-Wheel Torque
Force is measured at the crank through the full travel length and recorded on the batch sheet.
Assembly Tolerance
Bay length and diagonal, upright plumb and rail level are checked against the production drawing.
Lock Function
Column locks and the total lock are cycled under rated load to confirm engagement and release.
Where NM-01
Performs Best.
Long document runs where a single aisle must open without power, wiring or a control board.
Restricted-access storage where electronics and wireless devices are not permitted.
Small-parts and fastener storage in unconditioned sheds and workshops.
Storage that has to stay accessible through power and network outages.
Pure-White,
Installed.
A drawer-based pure-white manual compactor fit-out for small-parts storage – screwless clip-fit assembly and sealed hand-wheel bearings.
- Screwless clip-fit panel assembly
- Sealed hand-wheel bearings
- Drawer modules mounted on mobile runs
Specify NM-01 For Your Project
Provide room dimensions, bay count and load profile. Our engineering team will return a CAD layout and a factory-direct quotation within one working day.